Regular maintenance of computer spring machine

Regular maintenance content of computer spring machine:

According to the maintenance requirements of various mechanical equipment, after reaching the specified working hours or specified mileage, corresponding regular maintenance must be carried out, including the following:

1. Primary maintenance: Primary maintenance work is carried out on the basis of routine maintenance. The key tasks are lubrication, tightening and inspection of various relevant parts and cleaning of the “three filters” work (i.e. clean air, oil, fuel filter) Cleaner, etc.). The first-level maintenance is guided by the mechanical team leader and completed by the mechanical operator.

2. Second-level maintenance: The second-level maintenance work focuses on inspection and adjustment. Specifically, the engine, clutch, transmission, transmission mechanism, steering and braking mechanism, working device, hydraulic system, and electrical system should be checked and necessary Adjust and eliminate the faults found to ensure that the mechanical assemblies and parts have good working performance. The secondary maintenance is completed by the mechanical operator with the assistance of the warranty personnel.

3. Three-level maintenance: The focus is on detecting, adjusting, eliminating hidden troubles and balancing the degree of wear of various parts. It is necessary to diagnose and check the parts that affect the performance and the parts with fault signs, and then complete the necessary replacement. , Adjustment and troubleshooting, etc. The three-level maintenance requirements are completed by comprehensive technical maintenance personnel with the help of advanced testing instruments and tools.

(3) Special maintenance 1. Running-in maintenance: New machines or machinery after major repairs must be run-in maintenance during the running-in period. When the machinery is used within the specified running-in period, the load and speed must be gradually increased according to the corresponding regulations , And comprehensively check the lubrication and tightening conditions, observe the conditions of all parts of the whole machine, and solve the abnormalities in time. The focus of running-in maintenance is to replace the lubricating oil, lubricate each part, and tighten each bolt. After the running-in period is over, perform a second level maintenance.